Model and documentation reference
Selected documentary reference: Base Station article 509162, SEK UHF article 509164 and DAD UHF article 509169. These components establish no available or authorized system in Argentina. References are Spectera manual v1.5.0 October 2026, network guide v2.0 and security guide v1.0 September 2025. Identify actual band, zone/license, activation and installed firmware before final planning.
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages
Event application
For an event in Argentina, record who speaks/performs, who prepares their mix and which cues they should receive. Separate speech to room/stream from monitoring to the person: one Base Station does not imply the same channel or content. Draw intended stage positions, travel and audio/RF owners. Mobility needs project-specific system/region review and rehearsal; this guide assigns no frequencies or listening levels.
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages
Four distinct functions to record
| Part | Documented function | Project record |
|---|---|---|
| SEK Mic/Line | Source transmitted from the mobile device | Exact microphone/line source, mode and console destination |
| IEM return | Mix transmitted to the mobile | Origin, channel, mono/stereo mode and owner |
| Base Station / Dante | Up to32 documented audio inputs and 32 outputs | Required channels/subscriptions per direction |
| Antenna / Control / Dante | Different port roles despite RJ45 format | Labels, paths and responsible administrator |
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages
Trace both audio directions and a separate control path
Create a Mic/Line row: SEK source, link, DAD, Base Station audio output and console input. For IEM, start with the console mix, then Base Station input, link and intended receiver. WebUI provides control/observation, but a visible device establishes no complete audio path. The network guide distinguishes Shared and Split Network Mode; the administrator needs the actual control/Dante design rather than treating antenna, control and audio connectors as interchangeable. Record authentication ownership and authorized access as well.
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages · Spectera · Network Guide EN v2.0 · 09/2025 · Spectera · Security Guide EN v1.0 · 09/2025
Count resources with their conditions
Manual v1.5.0 allows up to 128 mobiles paired per RF channel, but pairing and simultaneous audio are different limits. Mode-table maxima of 128 links and 32 stereo IEM links require multiple Base Stations and a future cascade function; Cascade sockets establish no available capacity. Auto Mic/Line detection is optimized for Sennheiser microphones and is not guaranteed for every third-party microphone. Identify actual source and intended mode before treating missing audio as an RF fault.
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages
Prepare by person and audio direction
- Identify Base Station, SEK and DAD model/variant, revision and documented region/license. Mark unknowns pending; do not transfer another system’s regional approval.
- Create a speech/line row per person with exact source, intended link, Base Station output and console channel. Auto detection does not replace source identification.
- Create a separate IEM row: source mix, Base Station input, link mode/channel and receiver. Name the listening/transition reviewer without setting a generic volume.
- Separate antenna, control and Dante plans. Record Shared/Split design and access owners; perform no license activation, pairing, network change or credential reset to complete this sheet.
- Agree on representative travel, speech and return rehearsal, window, pending observations and initial-state return. Actual RF capacity, latency and continuity remain untested.
Sennheiser Spectera · manual EN v1.5.0 · 10/2026 · selected pages
Frequently asked questions
Do 128 paired mobiles mean 128 simultaneous speech channels?
No. The manual separates pairing, RF modes and audio channels. Some mode maxima require multiple bases and a future cascade function.
Must Mic/Line and IEM use the same route?
No. Mic/Line sends a source toward the Base Station; IEM receives a mix from it. Record both directions, channels and destinations.
Does WebUI discovery confirm room and IEM audio?
No. Control, link and audio routing are separate checks; actual reception/listening remain for rehearsal.
Does Auto identify any microphone connected to SEK?
Third-party microphone detection is not guaranteed. Record model, source type and intended mode for review.
Is the documented UHF reference ready for use in Argentina?
This candidate establishes no such authorization. Confirm actual units, region, license and applicable local requirements before planning use; no frequency or availability is assigned.
Follow the audio path
Official edition-specific documentation
Three existing official English originals SHA verified: manual v1.5.0(10/2026), network v2.0/security v1.0(09/2025). Selective reading recorded; manual PDF 36/93/262, network 9 and security 6 visually inspected. No full 280/17/15-page reading claimed. Use the exact editions below and compare with the actual system.
