Model and documentation reference
Exact model: ENTTEC S-PLAY SP1-1, code 70092. Data sheet ID 4690558 dated October 2025 identifies Rev.C in ordering information; web manual ID 4686708 is dated January 2026. Neither establishes a particular unit revision or firmware. S-PLAY Lite, Mini, Nano or SP1-16 limits are not transferred.
Event application
Prepare a matrix with scene, purpose, intended duration, trigger and return state. A repeating atmosphere may suit prepared playback; an unpredictable demonstration requires an operator/console decision. Distinguish recorded content from signals starting or stopping it. Agree on the staff interface, permitted buttons and interruption response rather than assuming any input or relay solves triggering.
Separate capture, internal universe and output
| Segment | This variant reference | Project information |
|---|---|---|
| Physical DMX capture | Up to 2 universes through five-pin XLR ports | Identified source and capture port |
| Art-Net / sACN | Up to 32 network universes | Protocol and external universe of each source |
| Stored cue | Static, Dynamic or Effect as prepared | Internal universe and intended channels |
| Playback | Output Settings assignment | Internal universe → protocol/destination or physical port |
| Operation | Agreed playlist and trigger | Observed start, repeat, stop and return |
S-PLAY SP1-1 manual · ID4686708 · January2026 · selectedsections
A capture number does not automatically define output
External source and S-PLAY internal universe belong in different columns. Record their correspondence when preparing the cue and add a playback-output column. Network output to additional physical lines requires compatible nodes: network capacity does not create thirty-two DMX connectors. Prepare a recognizable sample comparison with the capture source absent to check stored content; that test is proposed here, not performed.
S-PLAY SP1-1 manual · ID4686708 · January2026 · selectedsections
Design console handover at the receiving segment
Specific support warns against treating S-PLAY as a transparent node receiving Art-Net and directly producing DMX. For merging or handover, document an appropriate external node or merger and its behavior. Internal playlist priority resolves conflicts inside the player; it does not replace the network-source scheme. Define playback, active console, blackout and transmission cessation separately. They are different events, and return needs a test using the chosen receiver without an automatic-changeover promise.
S-PLAY SP1-1 manual · ID4686708 · January2026 · selectedsections · ENTTEC · S-PLAY node limitation · 27April2026
Document preparation for playback delivery
- Record observed code, revision and firmware, sources and patch. Preserve the current show before proposing edits; this candidate accesses no device.
- Prepare external source → internal universe → output mapping with channels, fixture personality and address. Name cues and playlists by staff-understandable purpose.
- Define the signal triggering each action and expected repeat, pause or stop behavior. Record owner and alternative; no input or load wiring is performed here.
- Agree on an off-program test of stored playback without the capture source, delivery through the selected output and visible response. Add console handover only when required by the design.
- Separate show backup and network information. The manual excludes IP address from backup and warns that restoring erases current shows. This preparation restores, updates or triggers nothing.
S-PLAY SP1-1 manual · ID4686708 · January2026 · selectedsections
Frequently asked questions
Are 32 universes 32 physical outputs?
The data sheet distinguishes two physical DMX universes from up to 32 Art-Net/sACN universes. For additional DMX lines, document conversion and mapping rather than extrapolating connector count.
Must the recording console remain connected?
Stored content is prepared for playback from the controller. Power, output, nodes and triggers remain necessary; testing without the original source must precede a validation claim.
Is capture equivalent to live forwarding?
No. Model support distinguishes recording from transparent-node operation. Confirm the required function and handle merging or handover externally where appropriate.
Does Stop guarantee the intended room state?
Define the required outcome and check it against actual playlist, outputs and firmware. The button name establishes no blackout, cessation of another source or playback return.
Does a backup file recover everything?
The described backup omits IP address. Preserve network details separately and agree on current-show recovery; do not test restoration over live programming.
Follow the lighting control path
Official edition-specific documentation
70092 data sheet ID 4690558, October 2025: both pages read and p. 2 visually inspected, including Rev.C identification. Web manual ID 4686708, January 2026: Cue, Output Settings, Playlist Playback Configuration and Backup/Restore sections consulted; no whole-manual reading claim. Node-use support, April 2026. No firmware, software, credentials or electrical installation procedures copied.
