EVENTOS GLOBALES — CONVERSION, SOURCE CHANGES AND AUDIO Optional worksheet. Write “to be defined” for unknown items. Saving it does not configure equipment, reserve availability or send an enquiry. Goal / event / city / date if known: Each team’s contribution / scope to quote: Who authorizes off-air testing / operator: Source and actual content: laptop, camera, playback: Destination and owner: display, switcher, capture device, recorder: Source output format / receiver supported format: Converter model, serial prefix and installed firmware: Applicable manual / initial state and recovery settings: PATH PER OUTPUT HDMI or SDI input / scaler source / scaler format: Selected reference and signal present / reason for reference: SDI OUT SOURCE / HDMI OUT SOURCE / actual BNC / loop state: Format detected at each receiver (not only Input Status): SOURCE CHANGE Laptop A: H and D if applicable / received format / content: No source: input state / output / observed interruption: Laptop B: new format / picture and audio recovery: Border-and-circle pattern: bars / cropping / distortion / text: Motion in actual content / result per destination: AUDIO Pairs present at source and expected at each output: Initial HDMI Out Pair / SDI Out Pair values if supported: HDMI OUT TYPE / type and channels accepted by receiver: Channel identification and actual-content listening: Remote return: mix-minus owner / destination / result: Test tones and overlays removed where present on actual variant: TEST CLOSURE Final settings and save state / owner: Before-and-after sample / actual result / pending issue: Recovery prepared / next-action owner: A correct pattern does not verify the source; a tone does not verify content. Parameter changes may affect output immediately. Compare off-air with recovery prepared. This worksheet is not a firmware or installation procedure. To continue, open Contact and summarize the goal. Do not put credentials or private client data in links.